The Official DSI/Sequential Forum

BUG report in OB-6 Desktop tuning

BUG report in OB-6 Desktop tuning
« on: July 07, 2017, 02:19:07 AM »
Ok, I don't have a big problem with it keeping overall in tune...but what IS out of tune is the voices are not in tune with each other.

Here's an experiment for you to try OB6 users and test it for yourself, I believe it is a bug in the tuning.

Hit your calibration function, wait for it to tune....

Then hold manual and press write to give you a new patch....

to make it easy to hear put vco 1 on square and bring up the volume....put vco 2 on square and equal it's volume to osc 1...

detune the oscillators to taste.....I like to detune it to where there's slow motion beating on the lowest notes but not too much that it makes the high notes sound "squiggly"....the "sweet spot", so to speak.

Now, hit the same note repeatedly so you can hear the rate of the pulse of the two oscillators beating against each other.....the OB6 will "round-robbin" through the voice cards.....you'll notice that the tuning of these voice cards are out of tune from each other because the beating rate changes pretty drastically depending on which voice card is selected...  the voice cards are NOT in tune with each other...  So the effect of this is that detune of vco 2 effects some voice cards more than others.

So the effect of this is, getting your detuning just right like I described below sometimes the beating will be static, sometimes the beating will be fast, and other times medium.  The OB6 is not in tune with itself.

Sucks when you have the detune on the low notes just right and some times you hit that lowest note and it's just static....the opposite effect happens on the high notes...makes it impossible to hit that "sweet spot"

« Last Edit: July 07, 2017, 02:38:13 AM by John01W »

Re: BUG report in OB-6 Desktop tuning
« Reply #1 on: July 08, 2017, 07:46:37 AM »
Basically, just saying the calibration doesn't tune all the voice cards together accurately enough(test it immediately after calibrating)...2 or so of them are a few or more cents off.  Wish the calibration was a bit tighter between the voice cards.
« Last Edit: July 08, 2017, 07:48:49 AM by John01W »

autoy

Re: BUG report in OB-6 Desktop tuning
« Reply #2 on: July 12, 2017, 03:17:24 AM »
No, please don't make the tuning tighter between cards. Big reason to get the OB-6 is to have tuning a bit loosened up.

Re: BUG report in OB-6 Desktop tuning
« Reply #3 on: July 12, 2017, 09:44:54 AM »
No, please don't make the tuning tighter between cards. Big reason to get the OB-6 is to have tuning a bit loosened up.

Did you test yours?  Good grief man,  I DON'T WANT super tight tuning between the cards, and I agree with you that it being slightly loosened up is a good thing and I already love the sound of the OB6, but 1 or 2 of the cards is much more so, so much that it "barks" from time to time(this is immediately after a calibration).  I can see I'll have to post clips to demonstrate. 


Again, did you test it?
« Last Edit: July 12, 2017, 10:52:01 AM by John01W »

Re: BUG report in OB-6 Desktop tuning
« Reply #4 on: July 12, 2017, 09:45:32 PM »
Here is what mine is doing.  Test settings, hold manual, press write...then these settings vco 1 and 2 both sawtooth...NO detuning, same volume....no midi controllers/aftertouch enabled, no pedals plugged in...nothing else turned on...directly after a calibration:

voice card 1  nowhere above .5 cents difference (good, natural)
voice card 2   about the same(natural good variance, what we want)
voice card 3   about the same(same, good variance but not "out")
voice card 4  4/5 cents off(drives me NUTS when trying to get accurate detunes with rest of notes, it BARKS)
voice card 5   somewhere like first 4
voice card 6   1-2 cents off

as you can see, I LIKE the natural looseness...but this 4-5 cents off thing drives me NUTS!  By the time you bring up the detune on MOST of the voices just right,  the "BARKER" adds it's 4/5 cents to whatever detune you do and it can howl in the high/mid high ranges.  Is it just my unit?
« Last Edit: July 12, 2017, 09:57:26 PM by John01W »

Re: BUG report in OB-6 Desktop tuning
« Reply #5 on: July 13, 2017, 09:07:37 PM »
No, please don't make the tuning tighter between cards. Big reason to get the OB-6 is to have tuning a bit loosened up.

BTW, I'll state it again....I AGREE with you.....I do not want to do anything that would change the OB6 sound(I LOVE IT), I just have some outlier voices in tuning  and I'm at the point of humoring the possibility that it MAY be a voice card possibly but I need to call the good folks at DSI before jumping to that conclusion......(OB6 is a masterpiece guys, inspires me to write/tweak sounds like no synth I've had before)

I'm with ya autoy!